Sailing guide
Sailing the Baltic Sea: weather models, radio and a daily routine
On the Baltic, most sailors use a fine-grid regional model for today and tomorrow, a global model and an ensemble for the days after, and the NAVTEX or VHF forecast as the official word. The regional models run every three hours, so a fresh run is usually out before breakfast.
Updated 30 October 2026. Times are in UTC and come from Ilma’s model and radio schedules.
What makes Baltic weather different
- Short, steep waves. The Baltic is shallow and its basins are small, so waves do not have room to grow long. A wave of one and a half metres with a short period feels much rougher than the same height in ocean swell.
- Sea breezes. On warm, sunny days in summer the land heats up faster than the sea, and a breeze blows in from the sea in the afternoon. It can add several knots near the coast and turn the wind, then fade in the evening.
- Cold water in early summer. In May and June the sea is still cold. Air over it is stable, so the wind out at sea can be weaker than on land, and fog can form when warm air drifts over cold water.
- Archipelagos. In the Stockholm, Åland and Turku archipelagos and around the Estonian islands, the wind is funnelled between islands, gusty in their lee and turned by every headland. A model shows the wind over a grid box, not between two islands: Wind: mean, gusts and coasts.
- Water level, not tide. The tide is tiny. Instead, a strong wind pushes water to one end of a gulf, and low pressure lifts the sea. Harbour depths can change noticeably over a day of strong wind.
- Ice in winter. The northern Gulf of Bothnia freezes every winter, and in many winters the Gulf of Finland and Gulf of Riga too. Ice charts matter from late autumn to spring.
- Summer thunderstorms and autumn gales. Thunderstorms can bring sudden squalls in July and August. From September, lows come through more often and gales become common.
Which models to use, and where
- Global models cover everything and look furthest ahead. ECMWF IFS, ICON and GFS are the usual choices for planning two to seven days ahead. Their grids are too coarse to show the archipelagos.
- ICON-EU covers all of Europe, including the whole Baltic, with a grid of a few kilometres. It is a good common base wherever you sail.
- MEPS is the shared Nordic model of Norway, Sweden, Finland and partners. It covers Scandinavia, Finland and the whole Baltic on a fine grid, and is a common choice for the Gulf of Bothnia, the Gulf of Finland and the Swedish and Finnish archipelagos.
- DMI HARMONIE is the Danish fine-grid model. It covers Danish waters and most of the Baltic, but not the eastern Gulf of Finland.
- ICON-D2 is the German model with the finest grid of these, but it only reaches the western and southern Baltic: Kiel, the Danish islands, the German and Polish coasts and southern Sweden. It looks two days ahead.
- National models add local detail: EstHARMONIE for Estonia, the Gulf of Finland and the Gulf of Riga, and ALARO-PL and ICM UM for the Polish coast. Ilma lists them, but has no publication times for them yet.
- Ensembles such as ECMWF ENS and ICON-EPS show how sure the forecast is, which helps when you plan a longer crossing several days ahead: Ensembles and probabilities.
Side by side: MEPS vs ICON-EU, MEPS vs DMI HARMONIE and ICON-EU vs ICON-D2. Every model that covers the area is listed in Best weather models for sailing the Baltic Sea.
When to trust which model
- Today and tomorrow, near the coast: lean on a fine-grid regional model that covers your area. It shows sea breezes, the wind along the coast and the effect of large islands better than a global model.
- Two days and more: the global models and the ensemble are the better guide. A fine grid does not make a forecast for day four more certain: Resolution in km and nm.
- Before an open crossing, such as from Åland to Sweden or from Gotland to the mainland: compare two regional models and one global model. If they agree on the wind for the whole crossing, you can go with more confidence. If they differ, plan for the stronger one.
- Fronts and lows: models often agree on a low but differ by some hours on when its front arrives. Watch the timing across several runs, not just the strength.
- Thunderstorms: no model can say exactly where a storm will form. Treat showers and instability in the forecast as a warning that squalls are possible, and watch the sky.
The method in more detail: Using several models together.
When the new runs arrive
A run is named after the time it starts from, such as 00Z or 03Z. Its files appear later, the early forecast hours first. From the 03Z cycle, first data typically appears from ICON-D2 around 03:45 UTC, MEPS around 04:40 UTC, DMI HARMONIE around 04:35 UTC and ICON-EU around 05:40 UTC. From the 00Z cycle, first data typically appears from ICON around 02:40 UTC, GFS around 03:30 UTC and the ECMWF IFS around 07:35 UTC.
Global models
Regional models
| Model | Runs | First data, typically around (UTC) | Complete after run time |
|---|---|---|---|
| ICON-D2 | eight times a day | 00:45, 03:45, 06:45, 09:45, 12:45, 15:45, 18:45, 21:45 | 1 h 21 min |
| HARMONIE DINI (DMI) | eight times a day | 01:35, 04:35, 07:35, 10:35, 13:35, 16:35, 19:35, 22:35 | 2 h 58 min |
| HARMONIE MEPS (Nordic) | eight times a day | 01:40, 04:40, 07:40, 10:40, 13:40, 16:40, 19:40, 22:40 | 2 h 26 min |
| ICON-EU | eight times a day | 02:40, 05:40, 08:40, 11:40, 14:40, 17:40, 20:40, 23:40 | 2 h 50 min to 3 h 38 min |
Ensembles
Waves
| Model | Runs | First data, typically around (UTC) | Complete after run time |
|---|---|---|---|
| DWD GWAM / EWAM / CWAM | twice a day | ≈ 04:10, 16:10 | ≈ 4 h 11 min |
| ECMWF WAM | four times a day | 07:35, 12:25, 19:35, 00:25 | 6 h 27 min to 7 h 34 min |
Times are typical and can vary from run to run. Figures marked ≈ are estimates. More models are on the GRIB download times page, and the reasons for the wait are in When does a new run arrive?
Waves, water level and ice
- Waves. Baltic wave models include FMI WAM from Finland and the Swedish and Danish SMHI and DMI wave models. The wave models of DWD and ECMWF in the table above also cover the Baltic. Read the period as well as the height: Waves: height, period and swell.
- Currents and water level. Copernicus Baltic, DMI HBM, NEMO-Nordic from SMHI and the German BSHcmod forecast currents and sea level. Currents are weak in most of the Baltic but matter in the Danish straits and narrow sounds: Ocean current and surge models.
- Ice. For early or late sailing, and for winter, use the Baltic ice charts from the Finnish and Swedish services. Copernicus Baltic and DMI HBM also forecast ice.
A daily routine on a coastal cruise
- The evening before: look at a global model and the ensemble for the next few days, and pick the day’s plan: which leg, and a fallback harbour.
- Morning: the 03Z regional runs are typically all out by about 06:00 UTC (09:00 summer time in Finland and the Baltic states, 08:00 in Sweden, Denmark, Germany and Poland). Check the wind and gusts along your leg in one or two of them. The 00Z global set follows by about 07:35 UTC.
- Before you leave: read or listen to the official forecast and any warnings, on NAVTEX or VHF, for your sea area.
- On the way: watch the sky, the barometer and the water. A sea breeze, a shower line or a wind shift often comes before the forecast says.
- Evening: the 12Z regional runs are typically out by about 15:40 UTC (18:40 summer time in Finland and the Baltic states, 17:40 in Sweden, Denmark, Germany and Poland). Compare them with what you saw during the day: Checking a forecast against reality.
On a phone with mobile data, a small area and a short forecast are enough for a coastal day: a box around your leg, the finest grid the model has, wind, gusts and pressure, and 48 hours. More on file sizes in GRIB files.
NAVTEX and VHF forecasts
NAVTEX prints forecasts and warnings on a small receiver on board, with no internet. Most Baltic stations transmit in English on 518 kHz; some also have a national service on 490 kHz.
| Station | Frequency, language | Weather forecasts (UTC) |
|---|---|---|
| Bjuröklubb NAVTEX [H] | 518 kHz, English | 05:10 and 17:10 UTC |
| Tallinn NAVTEX [F] | 518 kHz, English | 04:50 and 16:50 UTC |
| Stockholm (Gislövshammar) NAVTEX [J] | 518 kHz, English | 01:30, 05:30, 09:30, 13:30, 17:30 and 21:30 UTC (every slot; which ones carry the forecast varies) |
| Grimeton NAVTEX [I] | 518 kHz, English | 01:20, 05:20, 09:20, 13:20, 17:20 and 21:20 UTC (every slot; which ones carry the forecast varies) |
| Pinneberg NAVTEX [S] | 518 kHz, English | 03:00, 07:00, 11:00, 15:00, 19:00 and 23:00 UTC |
| Pinneberg NAVTEX [L] | 490 kHz, German | 01:50, 05:50, 09:50, 13:50, 17:50 and 21:50 UTC |
Times are in UTC and come from the station schedules on Ilma. Check the operator's notices before you rely on them.
New to NAVTEX? Read how NAVTEX works and how to read a message, or see every NAVTEX station with its schedule.
Coast radio stations read forecasts and warnings on VHF, after an announcement on channel 16, and public radio has sea weather bulletins in the local languages. Each country’s stations and times are on its radio page:
| Country | Listed on Ilma |
|---|---|
| Estonia | 1 NAVTEX station, 1 VHF coast station and 1 HF radiofax station |
| Finland | 2 NAVTEX stations, 1 VHF coast station, 1 public radio station and 1 HF radiofax station |
| Sweden | 3 NAVTEX stations, 1 VHF coast station and 1 public radio station |
| Denmark | 1 VHF coast station |
| Germany | 2 NAVTEX stations, 1 VHF coast station, 1 public radio station and 1 HF radiofax station |
| Poland | 1 VHF coast station and 1 public radio station |
| Lithuania | 1 VHF coast station |
| Latvia | 1 VHF coast station |
Country by country, with each national weather service, its marine forecasts and models: Estonia, Finland, Sweden, Poland, Germany, Denmark, Latvia, Lithuania.
Find each station’s times in your time zone on the radio page, or what reaches a point on the map. Sailing from Finland or Estonia? The Tallinn and Bjuröklubb stations above cover the northern Baltic.
How Ilma helps
When is the next forecast out? Get a push or alert the minute it is. Ilma shows when each model’s next run is due, with countdowns in your time zone. With a free account you can get a push notification when a run you follow is published, and add the expected run times to your calendar. The map shows which models and radio stations cover your harbour.
Free. No card needed.
Questions sailors ask
What is the best weather model for sailing in the Baltic?
It depends on where you sail. Fine-grid regional models such as the Nordic MEPS, DMI HARMONIE and ICON-D2 show more of the coast and the archipelagos than a global model, but each covers a different area. Most sailors use one regional model for the next two days, a global model for the days after, and compare them before a longer crossing.
When are new Baltic weather forecasts available?
Some time after the run time. The regional models run every three hours and their files appear one to three hours later. For example, the 03Z run of MEPS typically starts to appear around 04:40 UTC and ICON-EU around 05:40 UTC, and the main regional models are usually all out by about 06:00 UTC. Global models take longer.
Why are Baltic waves so uncomfortable?
The Baltic is fairly shallow and its basins are small, so the waves are short and steep for their height. A wave height that would feel easy in long ocean swell can be hard going here, especially when the wind blows against a current or across shallow banks. Look at the wave period as well as the height.
Is there tide in the Baltic?
Almost none. The water level changes with wind and air pressure instead, and in a strong, steady wind it can rise or fall noticeably, most at the end of long gulfs. Ocean models and the national water-level forecasts show this.
Where can I get Baltic weather without internet?
NAVTEX on 518 kHz carries forecasts and warnings in English from stations around the Baltic. Coast radio stations read forecasts and warnings on VHF after an announcement on channel 16, and national public radio has sea weather bulletins in the local languages.